In today's competitive manufacturing landscape, the quality of custom injection molds directly determines product competitiveness. High-quality molds significantly improve production efficiency and reduce defect rates. Mastering key points in mold customization is crucial for achieving high-quality production. Here’s a concise guide to core processes.

1. Accurate Definition of Requirement Parameters

Clear parameter transmission avoids later modifications. Specify basic parameters: geometric dimensions, precision grades (IT7 for electronics, IT8-IT9 for industrial parts), and surface quality standards (Ra ≤0.8μm for appearance parts, ≤0.4μm for precision fittings).

Annual output projections influence design: simplified structures for small-batch production (≤10,000 units/year) and durable designs with high-quality materials for mass production (≥100,000 units/year). Provide standardized 3D models (STEP/IGS) and 2D drawings with tolerances, draft angles (minimum 1°), and wall thickness requirements (uniformity with ≤20% variation).

2. Optimal Design of Core Structures

Parting surfaces should be at maximum contours for smooth demolding, avoiding appearance and critical fitting surfaces with 間隙 ≤0.02mm.

Gate design depends on part structure: 0.5-2mm diameter pin gates for small parts; side gates (1-1.5×wall thickness) for medium parts; fan gates for large components. Use flow analysis to optimize gate positions and reduce weld lines.

Cooling systems use conformal water channels (15-25mm from cavity surfaces) with ≤5℃ temperature variation. Add channels in thick sections. Venting grooves (0.01-0.03mm deep, 5-10mm wide) at last-fill areas prevent burning and short shots.

3. Scientific Matching of Materials and Processes

Choose materials based on production and precision needs: Pre-hardened steel (718H, HRC30-35) for mass production (≥100,000 cycles); mirror steel (S136, Ra 0.02μm) for precision/transparent parts; high-strength alloy steel (H13, HRC45-50) for large molds.

Surface treatments include hard chrome plating (5-10μm, HV800+) for wear resistance; nitriding (5-15μm layer) for anti-adhesion; ultra-fine polishing for transparent part molds.

4. Scientific Supplier Selection

Evaluate technical strength: designers with ≥5 years' experience, precision equipment (high-speed machining centers, CMMs), and ISO9001 certification. Prioritize suppliers with industry experience.

Assess digital capabilities (CAD/CAE/CAM integration, MES systems). Confirm after-sales support: 1-year or 50,000-cycle warranty, 24-hour response, and clear technical agreements specifying precision, test runs, and delivery timelines.

5. Standardized Trial and Acceptance

First trials use mass production materials, recording parameters (temperature, pressure, speed, cooling time) with 30-50 test pieces.

Post-trial inspections include dimensional accuracy (CMM measurements), surface quality (no shrinkage, flash, bubbles), structural integrity, and mechanical properties.

Acceptance requires complete documentation: drawings, material certificates, heat treatment reports, and test data. Validate stability with 500-1000 piece trial runs (defect rate ≤50 PPM). Establish mold archives for maintenance and production reference.

Custom injection mold manufacturing demands strict control over parameter transmission, design, material selection, supplier management, and acceptance. Combining expertise with practical experience ensures high-quality molds supporting efficient production.